Sealey SJBEX200LP Manual de usuario descargar pdf (Pagina 2)

4. OPERATING INSTRUCTIONS

NOTE: To assist in matching different runner height arrangements

the wheels on the arms can be mounted in one of 3 positions

as shown in the diagram below.

4.2. Locating jacking beam in a conventional inspection pit.

NOTE: Therollerarmsshowningures5&6arenotsuppliedwith

the unit but are available as optional extras.

4.2.1 Fittheoptionalrollerarms(see'B'ing.5).

4.2.2 Extend the roller arms (B) to the correct width for the

 inspectionpitrunners.Seegs.5and6below.

4.2.3 Lower the jacking beam into the pit and locate the rollers onto

the runners. With the beam central in the pit lock the arms

in position by tightening the two locking bolts 'X' seen in

  g.5below.

4.2.4 Adjust the spring tension screw on all four rollers (see 'T' in

  g.6)sothattherollerswilljustsupporttheweightofthe

jacking beam on its own and allow it to travel freely over the

pit. When the jacking beam is in use the weight of the vehicle

will overcome the spring tension, pushing the jacking beam

downwards until the roller arms themselves make contact

with the sides of the pit.

4.3. To jack a vehicle.

Make sure the vehicle hand brake is on and automatic

vehicles are in 'park' before attempting to raise the vehicle.

4.3.1 With the beam in the lowered position, roll it under the

vehicle to the position where the lift is required.

NOTE: Ensure you use the vehicle manufacturer’s designated

jacking points.

4.3.2 The majority of lift applications require the use of two

saddles.

4.3.3 Evaluate which height extension posts may be required.

Fig.6

Fig.5

Fig.2

Fig.4

 WARNING! This jacking beam weighs 97kg. Seek assistance

before attempting to locate jacking beam on inspection pit

runners and Automatic Test Lanes.

4.1. Locating jacking beam in an ATL (Automatic Test Lane).

4.1.1 Extend the roller arms (A) to the correct width for the pit lift

 runners.Seegs.3and4below.

4.1.2 Lower the jacking beam into the pit and locate the rollers into

the lift runners. With the beam central in the pit lock the arms

 inpositionbytighteningthetwolockingbolts'X'seening.4

below.

Fig.3

Original Language Version

SJBEX200LP Issue: 3 - 16/10/09

1 2 3 4

Comentarios a estos manuales

Sin comentarios

Sealey SJBEX200LP Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Sealey SJBEX200LP